Automations and Flows for Pro in Homey
Build Homey Flows with Everything Presence Pro. Use presence detection and sensor readings to automate your smart home.
Build Homey Flows using the Pro's main motion alarm, static presence, tracking zones and relay controls. Pair the device first using the Homey setup guide.
Whole-room lighting
- Set the device's Motion Source to Occupancy (Combined).
- Create a Flow triggered when the Pro's motion alarm turns on.
- Add a condition for low light if needed, then turn on your room lights.
- Create a second Flow triggered when the motion alarm turns off, then turn the lights off.
Test while sitting still as well as walking. If lights switch off too soon, review the device's occupancy off delay. If you add a delayed off action in Homey, re-check that the room is still unoccupied before switching off so an old pending action does not turn lights off after someone returns.
Zone-based lighting
Configure and test a zone in Homey Sensors and Controls first.
- Use When a zone's occupancy becomes active, select the required zone, and turn on the light for that area.
- Use the corresponding inactive trigger for the off Flow.
- Use Any zone became active and All zones became inactive when an action should apply across your configured zones.
- Use a zone-active or zone-inactive condition when another event should run only while that area is occupied or empty.
Keep whole-room presence and zone presence separate in your design: a person detected by static presence is not automatically assigned to a tracking zone.
Static presence
The Pro provides Static presence became active, Static presence became inactive and Static presence changed triggers, plus active/inactive conditions. Use these when you specifically want the SEN0609 signal rather than the configurable main motion alarm.
Relay actions
Pro Flow actions include Turn relay on, Turn relay off and Toggle relay. Relay-on/off conditions and triggers are also available. Confirm the device's Relay Trigger Mode and intended wiring before using these actions; see Alarm Panel Integration.
Test your Flows
| Check | What to verify |
|---|---|
| Enter the room | The intended trigger runs and the correct light or action responds. |
| Remain still | Whole-room occupancy behaves as expected. |
| Move between zones | Each zone triggers only its intended actions. |
| Leave the room | Off delays and any pending actions finish correctly. |
| Return before a delayed off action | The Flow re-checks occupancy and keeps the lights on. |
| Restart or reconnect the device | Readings recover; automations do not mistake unavailable data for an empty room. |
Available Flow cards depend on the installed app version and selected device. Update the Everything Presence app if the Pro or its cards are missing.