SmartThings Sensors and Controls for EPL
Explore Everything Presence Lite sensors and controls in SmartThings and learn how to use the available device capabilities.
Everything Presence Lite appears in SmartThings with room presence, zone tiles, target tiles, and device controls.
Image placeholder: EPL SmartThings device overview showing Presence, Zone 1 to Zone 4, and Target 1 to Target 3
Main tiles
| Tile | What it means | Best use |
|---|---|---|
| Presence | Overall room occupancy | Use this for most room-level automations |
| Zone 1 to Zone 4 | Whether each configured zone is occupied | Area-specific automations |
| Target count | Number of tracked targets in a zone | More precise zone logic |
| Target 1 to Target 3 | Whether each radar target slot is active | Diagnostics and advanced routines |
| Illuminance | Current light level | Lighting automations |
| LED | Status LED control | Turn the device LED on or off |
| Restart Device | Restarts the device | Use when troubleshooting |
| CO2 | Carbon dioxide reading in ppm | Air quality automations, when the CO2 module is installed |
| Calibrate CO2 (Outdoor Air) | Starts CO2 outdoor-air calibration | Only use with the device in fresh outdoor air |
CO2 and Calibrate CO2 (Outdoor Air) only appear when the CO2 module is installed, EPL is running CO2-enabled firmware, and SmartThings has detected the CO2 sensor. Temperature and humidity are not shown for EPL in SmartThings.
Which tile should I use?
Use Presence for normal room occupancy automations.
Use Zone 1 to Zone 4 when you want different actions in different parts of a room, such as a desk area, sofa area, or doorway.
Image placeholder: EPL zone tile showing motion state and target count
Use Target 1 to Target 3 for diagnostics or advanced automations. These are radar target slots, not named people.
Settings
EPL settings in SmartThings include:
- Device address and port
- Occupancy off delay
- Maximum detection distance
- Illuminance offset
- Zone off delays
- Installation angle
- Exit threshold
- Upside-down mounting
- Entry/exit zone tracking
- Polygon zones
- Stale target cleanup
- Target-tracking detail level
- Update speed
Image placeholder: EPL SmartThings settings screen showing zone settings and tracking options
Zone setup note
SmartThings can use EPL zones once they are configured, but it is not a visual zone editor. Use Zone Configurator when you need to draw or adjust room zones.
Useful Zone Configurator references:
CO2 calibration
The CO2 calibration tile appears when the CO2 module is installed, EPL is running CO2-enabled firmware, and the sensor has been detected by SmartThings.
Image placeholder: EPL with CO2 module showing the CO2 reading and Calibrate CO2 tile
To calibrate:
- Move EPL into fresh outdoor air, or place it next to an open window with strong outdoor airflow.
- Power the device and leave it running for 3-5 minutes so the CO2 reading can settle.
- In SmartThings, open the EPL device.
- Press
Calibrate CO2 (Outdoor Air)once. - Leave EPL in fresh air for another few minutes before moving it back indoors.
Do not calibrate while the device is indoors, near people breathing on it, or in a poorly ventilated space. A bad calibration can make future CO2 readings inaccurate.
For module setup details, see Integrate the Carbon Dioxide (CO2) Module for EPL.