Everything Presence Lite — Integrate the Carbon Dioxide (CO2) Module
Add the optional CO2 module to Everything Presence Lite. Follow the hardware and firmware setup guide and check the sensor readings in Home Assistant.
Enhance your Everything Presence Lite with CO₂ monitoring.
Info
The CO₂ module is supported in Home Assistant. Homey support depends on your Homey app version.
Install the CO₂ Sensor
What you need
- Everything Presence Lite (powered off)
- CO₂ sensor module
Identify GPIO Pins
- Locate the GPIO pins in the bottom corner of the Lite board.
- The layout may vary depending on your board revision.

- The layout may vary depending on your board revision.
- Align the CO₂ sensor module with the pins, ensuring:
- 3.3V on the sensor matches 3.3V on the board.
- GND (Ground) on the sensor matches GND on the board.
- SDA (GPIO26) and SCL (GPIO27) pins are correctly aligned.
- Firmly push the CO₂ module onto the GPIO pins.

Install the CO₂ Firmware
To enable CO₂ monitoring, install the CO₂ firmware version on Everything Presence Lite.
- Using the flasher below select the following settings.
- Choose LD2450 as the default mmWave sensor.
- Select the CO₂ module.
- Choose between:
- Bluetooth firmware (if you need Bluetooth features).
- Non-Bluetooth firmware (if Bluetooth is not required).
- Click Connect and follow the on-screen instructions.
Verify CO₂ Sensor in Home Assistant
Once the firmware update is complete, the CO₂ sensor should automatically appear as an entity in Home Assistant.
Using the CO₂ Sensor
The CO₂ sensor measures carbon dioxide concentration in parts per million (ppm). Here's what typical readings mean:
| CO₂ Level | Meaning |
|---|---|
| 400-450 ppm | Fresh outdoor air |
| 450-700 ppm | Good indoor air quality |
| 700-1000 ppm | Acceptable, consider ventilation |
| 1000-2000 ppm | Poor air quality, open windows |
| 2000+ ppm | Significantly elevated, improve ventilation immediately |
Tip: CO₂ levels are a great indicator of ventilation quality. Use automations to trigger fans or send notifications when levels exceed your preferred threshold.
Calibrating the CO₂ Sensor
The SCD40 CO₂ sensor is factory-calibrated but may need recalibration over time for best accuracy.
When to Calibrate
- After installing the sensor for the first time
- If readings seem consistently off by more than 50-100 ppm
- After the sensor has been stored for a long time
- Periodically (every 6-12 months) for best accuracy
How to Calibrate
- Place the sensor in fresh outdoor air, or near an open window with good airflow
- Wait at least 5 minutes for the sensor to stabilize
- In Home Assistant, find the Calibrate CO2 button entity
- Press the button to calibrate to 419 ppm (current atmospheric CO₂ average)
Important: The sensor must be exposed to fresh air during calibration. Indoor air typically has higher CO₂ levels due to human respiration.