Everything Smart

Everything Presence Lite — Automations and Flows

Build Homey Flows with Everything Presence Lite. Use presence detection and sensor readings to automate your smart home.

Create useful automations (Flows) with Everything Presence Lite in Homey.

Prerequisites

Flow Basics

Recipe 1: Turn on a light when room is occupied

  1. In Homey, create a new Flow
  2. When: Select Everything Presence Lite > Motion Alarm turned on
  3. And (optional): Only after sunset
  4. Then: Turn on your chosen light or scene

Recipe 2: Turn off the light when room is empty

  1. Create a second Flow
  2. When: Select Everything Presence Lite > Motion Alarm turned off
  3. Then: Turn off the same light

Tip

Use the Occupancy Off Delay setting (device Settings) to prevent lights turning off too quickly. 15-30 seconds is a good starting point.

Recipe 3: Zone-based lighting

Trigger different lights based on which zone is occupied:

Flow A - Living room couch zone:

  1. When: Zone 1 Occupancy turned on
  2. Then: Turn on floor lamp

Flow B - TV area zone:

  1. When: Zone 2 Occupancy turned on
  2. Then: Dim ceiling light to 30%

Tip

Configure zones in the EPL device Settings before creating these Flows. Use the Everything Presence Zone Configurator in Home Assistant for easier visual setup, then the coordinates will sync to Homey.

Recipe 4: Entry notification

Get notified when someone enters a specific area:

  1. When: Zone 1 Occupancy turned on (configure Zone 1 as your entry area)
  2. And: Only during specific hours
  3. Then: Send push notification

Recipe 5: All zones clear = room empty

Turn everything off only when all zones are empty:

  1. When: Motion Alarm turned off
  2. And: Zone 1 Occupancy is off
  3. And: Zone 2 Occupancy is off
  4. Then: Turn off all lights in room

Advanced: Target tracking

For advanced use cases, you can trigger Flows based on target position, distance, or speed:

Example: Trigger an alert if someone is moving fast (speed > 1000 mm/s).

Troubleshooting

Symptom Likely Cause Fix
Flow doesn't trigger Wrong device or zone selected Verify device and zone in Flow settings
Zone never activates Zone not configured Set zone coordinates in device Settings
Lights turn off too quickly Off delay too short Increase Occupancy Off Delay in Settings
Multiple zones trigger at once Zones overlap Adjust zone coordinates to avoid overlap

Next Steps