Everything Presence One — Automations and Flows
Build Homey Flows with Everything Presence One. Use presence detection and sensor readings to automate your smart home.
Create useful automations (Flows) with Everything Presence One in Homey.
Prerequisites
- EP1 added in Homey and visible on the Devices tab
- At least one light or scene you can control from Homey
Flow basics
- When: the trigger (e.g., Motion turned on)
- And: conditions (e.g., only after sunset, or if a light is off)
- Then: the action (e.g., turn on a light)
Recipe 1: Turn on a light when motion is detected
- In Homey, create a new Flow.
- When: Select Everything Presence under apps > EP1 > Motion Alarm turned on.
- And (optional): Only after a certain time of day.
- Then: Turn on your chosen light or scene.
Warning
Screenshot of EP1 Homey Flow needed.
Recipe 2: Turn off the light when the room is empty
- Create a second Flow.
- When: Select Everything Presence under apps > EP1 > Motion alarm turned off.
- And (optional): Any optional conditions
- Then: Turn off the same light.
Recipe 3: Dim lights based on light level
- Create a new Flow.
- When: Select Everything Presence under apps > EP1 > Light level changes (measure_luminance).
- And (optional): Only when Motion is on.
- Then: Set light brightness.
Warning
Screenshot of EP1 Homey Flow with luminance trigger needed.
Advanced (optional)
- Combine temperature/humidity with presence to control HVAC scenes.
- Add a time window to limit automation to certain hours.
Verify
- Trigger each Flow by moving in front of EP1 or changing light conditions.
- Confirm actions run and show in Homey's Flow timeline.
Troubleshooting
| Symptom | Likely cause | Fix |
|---|---|---|
| Flow does not run on Motion | Wrong device selected or disabled trigger | Re‑select EP1 as the trigger device; check device status in Homey |
| Lights turn off too quickly | No delay or short timeout | Use the "Off Delay" controls for the PIR, mmWave or Occupancy sensor under device settings. See Homey Sensors and Controls |
| Brightness changes too often | Light level triggers too frequently | Add an "And" condition (only when Motion is on) or adjust thresholds |
Next steps
- Full capability list: Homey Sensors and Controls
- Home Assistant alternative: Set up your EP1 device in Home Assistant