Everything Smart

Everything Presence One — Hardware Overview

Explore Everything Presence One hardware, connections and components to understand your device before installation and setup.


Overview

There are several components that make up the Everything Presence One. Purchases made after November 28th 2024 will receive the units pre-assembled and ready to use. If you would like to know which components have been used in Everything Presence One they will be listed below.

Everything Presence One Board

Everything Presence One circuit board

The EP1 board is the main PCB for the device. It's where the ESP32 is located that provides Wi-Fi connectivity and is the brains of all of the sensors.

Directly on the EP1 board we have the following components:

mmWave Sensor

Warning

The DFRobot mmWave Sensor SEN0395 (for Rev 1.3 boards) and SEN0609 (for Rev 1.5 and later EP1 boards) are the only compatible and validated sensor currently - do not try to use a different sensor as you may cause damage.
DFFRobot mmWave Sensor for EP1

The mmWave comes included as part of the Everything Presence One Full Kit - if you purchased the board only then you will need to supply your own mmWave sensor.

SEN0395 vs SEN0609: Which Sensor Do You Have?

The EP1 has shipped with two different mmWave sensors over its lifetime. The sensor you have determines which features are available.

How to identify your sensor:

If you're unsure, the easiest way to check is in Home Assistant - look at the entities available for your EP1. SEN0609 users will see additional controls like "Trigger Sensitivity" and "Sustain Sensitivity" that aren't present on SEN0395.

Feature Comparison

Feature SEN0395 (Legacy) SEN0609 (Current)
Detection Range Up to 8 metres Up to 25 metres (default 12m)
Sensitivity Control Single sensitivity (0-9) Separate Trigger & Sustain sensitivity
Distance Control Max distance only Min, Max, and Trigger distance
Detection Modes Standard only Distance & Speed mode available
Distance Zones Beta feature No

What This Means for You

SEN0609 users have access to more advanced tuning options:

SEN0395 users have a simpler but effective setup:

Both sensors work excellently for presence detection. The SEN0609 simply offers more fine-tuning options for challenging environments.

Firmware Compatibility

Each sensor requires its own firmware variant:

Tip

If you need to reinstall firmware, make sure you select the correct variant for your sensor. Installing the wrong firmware will result in the mmWave sensor not functioning.

Motion Sensor PIR

Warning

The Panasonic EKMC series of sensor is the only compatible and validated sensor currently - do not try to use a different sensor as you may cause damage.
Panasonic EKMC PIR

The PIR comes included as part of the Everything Presence One Full Kit - if you purchased the board only then you will need to supply your own PIR sensor.

Part numbers for the PIR are one of the following:

Case

The case supplied with the pre-assembled version is an injection molded case, prior units shipped with a 3d printed case.

Everything Presence One Official CaseThe Official Case for the EP1 is available for purchase here or if you prefer to print your own, the STL is located on Printables

The case has 5 components - Front, Back, Stand, Ball Joint and Locking Ring.

Front

Everything Presence One Official Case Front

Back

Everything Presence One Official Case Back

Stand

Everything Presence One Official Case Stand

Ball Joint

Everything Presence One Official Case Ball Joint

Locking Ring

Everything Presence One Official Case Ball Joint