Alternative Setup Guide for EP1 in Home Assistant
Set up Everything Presence One in Home Assistant using the alternative installation method, with firmware installation and connection instructions.
Follow these steps to complete the alternative setup of your Everything Presence One if you are unable to use Bluetooth adoption:
- Select your device options\nOn the device flashing segment below, choose the appropriate options for your device.\n
- Complete the installation\nOnce the installation finishes, click Next to proceed.\n
- Configure Wi-Fi
- On the "Configure Wi-Fi" screen, select your network.
- Enter your Wi-Fi password and click Connect.\n
- Add your device to Home Assistant
- Open Home Assistant.
- Go to Settings → Devices & Services.
- Your device should now be ready to add.\n
Your Everything Presence One is now set up and ready to use.
Device Flasher
/flash/everything-presence-one.html
If you still need help
Choose the error or message that appears:
- Connect button does not appear on flashing page
- Failed to initialize. Try resetting your device or holding the BOOT button while clicking INSTALL.
- Preparing installation
If you're still unable to restore your EP1 to factory settings, contact us for further assistance. Get service, or join us on Discord to discuss with the community.