Everything Smart

How to update LD2450 Firmware

Update the LD2450 radar module firmware in Everything Presence Lite using the steps and tools described in this guide.

Follow these steps to update the firmware on your LD2450 sensor.

Enable the mmWave Bluetooth entity

Before updating, make sure the mmWave Bluetooth entity is enabled in Home Assistant:

  1. Open Home Assistant.
  2. Navigate to Settings > Devices & Services.
  3. Locate the mmWave Bluetooth entity and enable it if it is disabled.

Update the firmware using the HLKRadarTool app

  1. Install the HLKRadarTool app:
  2. Stand near the EPL device.
  3. Open the HLKRadarTool app and connect to the LD2450 sensor.
  4. Update the firmware to version 2.04.23101915 or later.

Tip

If the HLKRadarTool app crashes on iOS, use RadarTools instead.
Warning

If upgrading to version 2.14 or later, you must set the baud rate back to 256000. This update seems to change the baud rate. If you do not change it back, the EPL will not receive any sensor information.

Disable the mmWave Bluetooth entity (Optional)

After updating, you can disable the mmWave Bluetooth entity to prevent unauthorized access:

  1. Open Home Assistant.
  2. Navigate to Settings > Devices & Services.
  3. Toggle the mmWave Bluetooth entity off.

If the entity is no longer needed, you can disable it entirely.